Good vid Mac, especially for a first effort, I know because I recently tried to take some footage with a new Muvi Cam I got, and I had to throw away every second of it because it was so bad. The problem is, I was hand holding it and I'm just not a good enough surfer to do that.
Speaking of which, I'm thinking of embedding a mount directly into the nose of the board using a modified leash plug.
I simply pushed out the stainless pin with a pin punch, cleaned up an 8M x 1.25 stainless set screw before covering it with PVA release agent (that's the blue stuff you see on the side of the screw).
Then for some strength, I threaded some fin rovings through the now empty pin hold and added a heap of finely chopped glass into the hole and the resin mix.
The used Q-cels in the resin mix (epoxy, because the only polyester I had was filler and that was too gluggy), along with some more finely chopped glass and poured it into the leash plug, then carefully push the set screw to the bottom, before plugging the pin holes to make sure all the resin did not fall out the sides.
Once it hardened, I just unscrewed the set screw and the came straight out leaving a perfect thread cut all the way to the base.
I was going to drill and tap, but I decided to do it this way because the thread would go deeper, even a plug tap would not go as deep.
Not sure yet if I'm going to use it, I first have to decide what sort of mount to put on top of it after I set it in the board.
, 
comon mac we need this 
even after i rode a long board today
