QLD
477 posts
If you have the ST4000 set up on the port hand you will have to reprogram the control head. The procedure is set out in the user manual.
42 posts
It is set up on the port side but I cant seem to find reprogramming on the hand book
NSW
1659 posts
I set my ST2000 up on the Port side. Works perfectly well if you remember +and - are opposite
when on manual. Is your compass set up correctly??.
QLD
1156 posts
Hi Mopo
I have the st4000+, the entire unit consists of the display the compass and the ram. To set it up on the other side you just reverse the wires that go to the ram in other words there ar 2 small spade connectors that connect the ram to the control head, just reverse those so that the colours do not match.
Hope that helps
NSW
7146 posts
Don't go reversing wires! You have to change the operating sense as per Phoenix's post.
I went through this brain tangle myself as mine operates the rudder trim tab.
42 posts
It used to work fine. then just out of the blue it started displaying no data so I replaced the main plug then the ram then the compass now it doesn't display no data it just goes full to one way or the other.
I am a little disappointed as I should have used the hundreds I spent towards a new one.
Les
42 posts
Does the St2000 unit have a separate compass or is it built in. if it is a built in compass is it ok with a steel hull as the St 4000 hand book says that the fluxgate compass has to mounted 1.2 Meters above the deck on steel hull boats
