That's nice, dear. I bet there are many banana-shaped things that you like that run on batteries.

Welcome to seabreeze...

Have you seen Stargate Atlantis? The replicants are in it........ scary little bastards!

When you ruin ryobi they have to leave for rep to assess for warranty. When you ruin an ozito, its Bunnings own brand - they swap immediately no questions.

word

adas34 said..
Oh OH, see. i really should have got the higher powered one. it still under powered. i hope i can get it too break, but it will may b e hard for me.

Correct - as you don't actually own a replicating saw. Or, do you mean a higher powered banana-shaped object... good for you.

Word. Dawg.

that alone should sound alarm bells

busterwa said..
No way near as good as strapping on the harness and going thru heavy bush with the still But for the misses perfect!

they are all badly made, all you need is a variable powerful motor. and a, heap, of attachments. such a waste. i also tried to hire one, @ 120 for the entire day, no hour rate :(.

MAN HARNESS !!!

Should have used a seat harness

and my lead, phillips drill bit, melted.

i tried to cut my old* stanley srew driver as a replacement, but the blade went blunt before i was `1mm in, or less, haha, phew, its a good screw driver. :).

Hey adas, are you sure you are old enough to be near power tools?
If you think something is missing, especially if the seal is broken, ask a shop assistant to go through the box with you, look for the pamphlet that lists the contents, if stuff is missing, but you don't really need it, ask for a discount on that particular unit, you will usually get it.
Did you melt a power lead or do you really have phillips drill bit made of Pb. You need to have at the very least a portable circuit breaker if your home ones aren't tripping out before melting ****. If you have purchased a Reciprocating saw, make sure you are using the correct blade for the job, try using Lennox brand blades from the U.S. And use the right tool for the job, read the f@cken instructions if its the first time you have used a particular tool, take 15 mins and do some online research.
How the hell did you melt a screwdriver drill bit, do you mean you rounded the edges off, are you using a variable torque drill when you are putting in screws? Cutting a screw driver to make a fitting for a drill doesn't work too well as the shaft is round, buy the proper screwdriver drill bit for power tools, should cost you less the $4, they are hexagonal for a reason.
Busterwa, what Ozito product did you buy to grind concrete with? Was it the 1100w variable speed timber sander /paint polisher, did you replace it with the Ryobi 1500w angle grinder / sander / polisher?

my last story with diy buunings. i bought a cheap metal drill bit. it broke. later i found the 13 piece drill bits worked but better on the metal. i dont know why they even make matal/wood drill bits, at all.

i guess you are mostly too young to understand, and yes i exaggerated.

this is a drill.




this is a...

no **** sherlock, you are missing the point.