Just applied RSPro clear to my new JL Striker 9'5, wished I had not. I followed the Vimeo instruction on Railsaver Website, being an X board maker I thought it would be easy, wrong! It was difficult to get the tape to bend to the contour of the rail, even after following the instruction I finished up with unwanted bubbles which I had to pin prick and squeegee out, some left a mark. Worse still I peeled back the tape to realign as per instruction and the tape took out a small piece of the rail, board looks poxy, so much for my new Jimmy Lewis Striker. I will never be able to match the yellow colour for repair. Any had this problem?