Can any board repair gurus out there advise if this heel compression repair is likely to work - any tips before i fk it up completely?






The plan is to set it in place with a thick epoxy/ glass powder mix, sand it flat and put 1 or two layers of 6 oz glass over the top with ~2 or 3 inch overlap around the hole

I suspect the plug is just gonna push straight through the bottom of the board first jump.

(The bottom skin is undamaged and plug is about half the thickness of the board)

I guess i need a weak resin mix otherwise the whole thing will melt into a sorry mess... not too sure on this

Cheers folks