So far so good.


Have no photos but this is now flat and has many layers of Quad matt and epoxy for added strength.
What I need to do next it make a raised section for the mast step to replace the pastibond that was doing the same thing.
I have some fiberglass sheet cut out collected from a speed boat factory there approximately 6 mm thick. I used some of it before making my instrument pod below
I have some flat pieces of this sheet
My intention is to rough all surfaces and epoxy three pieces together to mimic the original plastibond area .
question Good or bad idea ?






also I am thinking of fitted a Garhauer mast step plate